Gear change cable (page 3 of 5)

1. Lift the gearbox control cable retaining bracket to release it from the mounting bracket. 2. Working from inside the car, position the selector lever on P, remove the retaining bolt on the front of the selector lever handle and then withdraw the handle upwards, then remove the selector lever position indicator panel. 3. Release the driving mode switch panel, disconnect the electrical connectors and withdraw the panel. 4. Remove the plastic trim from the handbrake lever; slacken the tension from the relevant cable and disconnect the wiring connector for the handbrake on indicator. Place the car on ramps and carry out the following operations from under the car:

5. Remove the heat shield indicated. 6. Disconnect the cables operating the handbrake from the mounting and release them from the bracket.