Refitting

Refitting

Refit the gear change cable and selector lever by reversing the procedure for removal, bearing in mind the following:

• check that the gear change lever is positioned at P (lever fully forward);
• check that the selector lever is also set to position P;

• fit the gear change cable head (1) to the lever located on the gearbox. If the cable length needs to be adjusted, adjust the head (1) by screwing it or unscrewing it on the threaded part of the cable, then lock it with the nut (2). Finally fit the washer and split pin;
• operate the selector lever and check that, at each position, you can hear the gear change lever clicking into position.

Complete the assembly by securing the battery cage, i.e. control unit, battery and air intake duct.

Finally carry out the following checks:

• the engine must only start with the selector lever in position P or N;
• each position of the selector lever must be accompanied by the relevant indications on the indicator panel and instrument panel display.