Disc brakes (page 2 of 2)

- undo the attachment bolts and remove the brake caliper;

The caliper case attachment bolts are self-locking and should be renewed whenever they are slackened or unscrewed.

NOTE After replacing the brake calipers, adjust the handbrake.

- remove the brake pads;

NOTE Before fitting the new brake pads, make the caliper piston go in fully by turning it clockwise using tool 1856133000.
Also adjust the handbrake.

- undo the caliper support bracket bolts and remove the bracket.

Before refitting the caliper support bracket, check that the rubber gaiters are in good condition; if not, they should be replaced.

When refitting, remember to fit the shim between the bolts and support bracket.