Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)07 · 44 Suspension and wheels
07 · Steering & suspension

Removing-refitting

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Rear suspension › Removing-refitting
44 Suspension and wheelsRemoving-refitting · page 1 of 2

REMOVING-REFITTING

Undercarriage view showing the rear suspension, fuel tank, and exhaust system components.

NOTE To remove the rear suspension, first remove the fuel tank and the rear section of the exhaust pipe.

Fuel tank

A hand using a screwdriver to release a retaining lug on the circular plastic cover of the fuel tank access panel.

To remove the fuel tank, proceed as follows:

  1. remove the luggage compartment shelf trim and remove the plastic cover;
  2. disconnect the two wiring connectors;
  3. undo the nut and disconnect the vent pipe (1), then release the retaining lugs and disconnect the fuel delivery and return pipes (2);
Top-down view inside the fuel tank access panel showing two electrical wiring connectors being disconnected (indicated by arrows).
Top-down view inside the fuel tank access panel showing the fuel pipes, with callout numbers 1 and 2 indicating the vent pipe and fuel delivery/return pipes respectively.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.