Refitting (page 2 of 2)

• fit and tighten the rear fixing bolts, starting from the inside (1) and continuing towards the outside (2), to a torque of 2.4 daNm;

The seat should be fixed to the floor without the guides being distorted; if necessary act on the nuts, shown in the inset, making sure that they are free.

NOTE During this stage, do not lift the seat to fit the fixing bolts.

• place the seat in the "FULLY RETRACTED" position using the guide control lever;

Make sure that the guide control lever is correctly attached.

NOTE For the BRAVO avoid lowering the backrest to slide the seat in order not to loosen the guides which would result in them not being aligned.

• fit and tighten the front fixing bolts, starting from the inside (1) and working towards the outside (2), to a torque of 2.4 daNm.

The seat should be fixed to the floor without the guides being distorted; if necessary act on the nuts, shown in the inset, making sure that they are free.

NOTE Each time operations are carried out on the Air Bag system the operation of the system MUST, UNDER ALL CIRCUMSTANCES, be checked using the diagnostic equipment.