Code failure warning light on
- Make
- Fiat
- Model
- Doblò Factory Service Manual
- Year
- 2000–2010
- Section
- Instrument panel › Code failure warning light on
‹ Prev I.e. warning and code warning light both on / engine does not startNext › I.e. failure warning light off / (do not carry out initial test)
Fault diagnosisCode failure warning light on
CODE FAILURE WARNING LIGHT ON
The CODE warning light remains on permanently. The I.E. warning light carries out the initial test normally
| Results of the tests | ||||
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|---|---|---|---|
| Connect the diagnostic equipment (Examiner) to the diagnostic socket and check whether there are errors in the engine management control unit or the Body Computer | Continue to Step 2 | Errors detected in the control unit | Continue following the instructions for the diagnostic equipment | |
| Errors detected in the Body Computer | Continue following the instructions for the diagnostic equipment | |||
| 2 | SUPPLY CHECK | All OK | Problems met | Operation |
| 1.2 8v | Check the engine management control unit supply See E5030 PETROL ENGINE ELECTRONIC MANAGEMENT | Continue to Step 3 | No supply | Restore the correct supply See E5030 PETROL ENGINE ELECTRONIC MANAGEMENT |
| 1.9 DIESEL | Check the engine management control unit supply See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT | Continue to Step 3 | No supply | Restore the correct supply See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 3 | SAFETY STARTING | All OK | Problems met | Operation |
| 1.2 8v | Remove the supply for the Body Computer and start the vehicle using the recovery procedure by pressing the accelerator pedal | Continue to Step 4 | The engine does not start | Replace control unit Op. 1056B82 |
| 1.9 DIESEL | Remove the supply for the Body Computer and start the vehicle using the recovery procedure by pressing the accelerator pedal | Continue to Step 4 | The engine does not start | Replace control unit Op. 1060D80 |
| 4 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | The fault persists: Body Computer defective | Replace the Body Computer Op. 5505A32 Search for the fault starting from another symptom' | ||
‹ Prev I.e. warning and code warning light both on / engine does not startNext › I.e. failure warning light off / (do not carry out initial test)
Parts & tools for this job For 2000 Fiat Doblò
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Fiat Doblò
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.