GEAR ENGAGEMENT CABLE - R R

Operation 2125C30 · MANUAL GEARBOX EXTERNAL CONTROL (CABLES)

Removing

- Position the vehicle on the lift.

1. Release the two ends (1a), move the two gear selector and engagement flexible cables (1b) out of the slot in the bracket (1c) and place them outside of the work area.

1. Undo the fixing bolts.

2. Remove the lower dashboard trim.

3. Undo the fixing bolts.

4. Remove the lower steering column trim.

Op. 2125C24 GEAR LEVER KNOB - R + R

Op. 2125C26 LEVER/KNOB COVER - R+R FOR VERSIONS WITH REVERSE ENGAGEMENT DEVICE

1. Undo the fixing bolts.

2. Remove the dashboard gear lever trim.

1. Using a spanner, slightly rotate and release the ends of the gear selector and engagement cables.

2. Remove the springs securing the cables to the support.

1. Undo the fixing bolts.

2. Remove the dashboard trim on the floor.

1. Undo the retaining bolt.

2. Remove the plate fastening the transmission cables to the floor.

- Release the two gear selector and engagement cables downwards.

1. Working from the inside of the vehicle, remove the gear selector and engagement cables.

Refitting

- Fit the gear selector and engagement cables.

- Fit the plate retaining the transmission cables to the floor and tighten the fixing bolts.

- Fit the dashboard trim on the floor and tighten the fixing bolts.

- Connect the ends of the cables to the gear lever support and secure them fitting the springs.

- Fit the dashboard gear lever trim

Op. 2125C26 LEVER/KNOB COVER - R+R FOR VERSIONS WITH REVERSE ENGAGEMENT DEVICE

Op. 2125C24 GEAR LEVER KNOB - R + R

- Fit the steering column lower cover and tighten the fixing bolts.

- Fit the dashboard lower trim and tighten the fixing bolts.

- Connect the ends of the flexible cables to the bracket on the gearbox securing them by inserting them in the slot in the actual braket.