FRONT SUSPENSION BEAM - R R

Operation 4410D13 · FRAME AND CROSS BEAM

Removing

- Position the vehicle on the lift.

- Remove the front wheels.

Op. 7055B54 UNDER-ENGINE GUARD - R R

Carry out the next three operations on both the left and right sides of the vehicle.

1. Slightly loosen the upper nut fixing the anti-roll bar connecting rod.

2. Undo the lower nut fixing the anti-roll bar connecting rod.

3. Keep the washer (3a) and the bush (3b).

- Continue working on both sides of the vehicle.

1. Undo the front bolt for the track control arm.

2. Undo the bolts fixing the rear pin.

3. Gently lower the track control arm.

4. Keep the washer (4a) and the bush (4b).

Op. 4410D14 FRONT SUSPENSION CROSSBEAM - R+R WITH WISHBONES REMOVED

Refitting

Op. 4410D14 FRONT SUSPENSION CROSSBEAM - R+R WITH WISHBONES REMOVED

Carry out the next operations on both the left and right sides of the vehicle.

- Place the bushes and the washers in position, then raise the track control arms until they are in the correct position.

1. Tighten the inner bolt fixing the rear pin.

2. Tighten the outer bolt fixing the rear pin.

3. Tighten the front bolt.

4. Position the bush and the washer and tighten the lower connecting rod fixing nut.

5. Tighten the upper connecting rod fixing nut.

Op. 7055B54 UNDER-ENGINE GUARD - R R

- Refit the front wheels.

- Remove the vehicle from the lift.