Rear suspension end buffer - replace
- Make
- Fiat
- Model
- Ducato Factory Service Manual
- Year
- 2002–2006
- Section
- Rear suspension › Rear suspension end buffer - replace
‹ Prev Rear suspension axle -replace- includes r+r, check, parts transfer and bleedingNext › Front wheel geometry - check using optical equipment - includes front wheel tow-in adjustment if necessary
Suspension and wheelsRear suspension end buffer - replace
REAR SUSPENSION END BUFFER - REPLACE
Removing
- Position the vehicle on the lift.
1. Working underneath the vehicle, release the buffer (1a) from the housing (1b).
Refitting
- Check that the end of travel buffer is not damaged.
1. Lubricate the ring seal (1a) slightly with grease, then fit the buffer in position (1b).
- Check that the buffer is correctly fitted.
- Remove the vehicle from the lift.
‹ Prev Rear suspension axle -replace- includes r+r, check, parts transfer and bleedingNext › Front wheel geometry - check using optical equipment - includes front wheel tow-in adjustment if necessary
Parts & tools for this job For 2002 Fiat Ducato
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTRear shock absorbersSearch: Fiat Ducato 2002 rear shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.