1. Tooling (page 4 of 7)
- Make
- Fiat
- Model
- Ducato Mk3 (250) Factory Service Manual
- Year
- 2006–2017
- Section
- Windscreen: removing - refitting
10 Body front section1. Tooling · page 4 of 7
Figure : C5CG1DRD
Pass the awl [1354-C] through the bead of adhesive (At "c").
![A close-up photograph showing a tool labeled [1354-C] being inserted into the adhesive bead at point 'd' near the base of the windscreen, with a component labeled [1354-E] visible below.](/fiat/ducato-2006-2017/assets/page_1057_fig01.png)
Figure : C5CG1DUD
Thread the square section cutting wire [1354-E] in the awl [1354-C] and pass it (At "d").
Cut the end of the square section cutting wire [1354-E] leaving a sufficient length to permit fixing in the winding device [1354-AZ].
Fix the end of the square section cutting wire [1354-E] in the winding device [1354-AZ].
Parts & tools for this job For 2006 Fiat Ducato
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Fiat touch up paint
- PARTPanel clip assortmentSearch: Fiat panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.