Instrument panel - check power supply

Make

Fiat

Model

Grande Punto Factory Service Manual

Year

2005–2012

Section

Instruments › Instrument panel - check power supply

Electrical equipmentInstrument panel - check power supply

INSTRUMENT PANEL - CHECK POWER SUPPLY

Check 5560BR

- With an Examiner connected in Voltmeter mode with the postive probe at pin 3 and the negative earthed at pin 1 and with the ignition key on, check for a voltage reading of 12 Volts

- When an Examiner is connected in Voltmeter mode with the positive probe at pin 2 and the negative earthed, check for a voltage reading of 12 Volts

View of connector on insertion side.

INSTRUMENT PANEL PIN-OUT

Pin	SIGNAL
1	Earth
2	Battery (+ 30)
3	Key (+ 15)
4	N.C.
5	CAN A
6	CAN B
7	Reference signal for headlamp alignment actuators
8	+ dipped headlamps signal for headlamp alignment corrector control
9	Negative signal from trip button on steering wheel stalk unit
10	Input for warning light available
11	N.C.
12	N.C.
13	Control signal from “MODE +” panel
14	Signal from headlamp alignment corrector panel
15	Safety acoustic signal activation negative command from NCR
16	Control signal from “MODE -” panel
17	Warning light input available
18	I.E./EOBD failure warning light negative signal from NCM

16 Electrical