Introduction - CYLINDER HEAD/S
- Make
- Fiat
- Model
- Idea Factory Service Manual
- Year
- 2003–2012
- Section
- Cylinder head/s › Introduction - CYLINDER HEAD/S
‹ Prev Lower engine block - r r clean mating surfaces and apply sealant with engine removedNext › Cylinder head/s - various operations
EngineIntroduction - CYLINDER HEAD/S
Introduction - CYLINDER HEAD/S
The cylinder head is the monolithic type made from aluminium alloy.
The four valves per cylinder are mounted in their respective guides, operated by two camshafts via hydraulic tappets.
The valve guides are installed by interference fit in their seats in the cylinder head.
The inner diameter is finished off after assembly, using a specific reamer.
The camshafts are fitted in two integral camshaft housings, without a tappet cover.
The cylinder head gasket is the two layer metal type 0.5 mm thick and there is no need to retighten the cylinder head at all during the life of the engine.
‹ Prev Lower engine block - r r clean mating surfaces and apply sealant with engine removedNext › Cylinder head/s - various operations
Parts & tools for this job For 2003 Fiat Idea
- PARTEngine gasket setSearch: Fiat Idea 2003 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.