Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Multipla Factory Service Manual (1998-2010)22 · Fault diagnosis
22 · Diagnostics

Airbag failure warning light on

Make
Fiat
Model
Multipla Factory Service Manual
Year
1998–2010
Section
Instrument panel › Airbag failure warning light on
Fault diagnosisAirbag failure warning light on

AIRBAG FAILURE WARNING LIGHT ON

During starting, the air bag failure warning light comes on and remains on for more than 4 seconds. (after carrying out the initial control unit test, the warning light should go out, ...)

In the case of an impact which has cause the system to be activated, the warning light stays on The control unit memory cannot be cleared, so the control unit must always be replaced.

If the vehicle is not fitted with an Air Bag, a specific bridge is located on the back of the instrument, against the symbol indicating the relevant system: the warning light will stay on permanently if this missing.

Results of the tests
1CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket

Check:

  • there are no faults in the air bag control unit
  • plausibility of all the parameters
Continue to Step 2An error is detected in the control unitContinue according to the instructions for the diagnostic equipment
Lack of dialogue with the control unitRestore the connection between Air Bag control unit and diagnostic connector ( See E7030 AIRBAG)
2CHECK INSTRUMENT POWER SUPPLYAll OKProblems metOperation

The air bag warning light is fitted with an interior circuit that monitors the connection between warning light and control unit.

Check the connection betwen air bag control unit and instrument ( See E7030 AIRBAG).

Continue to Step 3Connections not correctRestore the connections
Instrument not workingChange the instrument Op. 5560B10
3CHECKING CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosisFault persistsSearch for the fault starting from another symptom'

Parts & tools for this job For 1998 Fiat Multipla

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.