1016 cylinder head/s – cylinder head

Make

Fiat

Model

Panda Factory Service Manual

Year

2003–2012

Section

10 engine › 1016 cylinder head/s – cylinder head

Manufacturing data and tolerances1016 cylinder head/s – cylinder head

1016 CYLINDER HEAD/S – CYLINDER HEAD

Combustion chamber volume (cm)		Validity
23.41		1.2 8v
Contact band width with valve "I" (mm)		Validity
c.a. 2		1.2 8v
Contact band with valve taper "b" (-)		Validity
44˚ 30'		1.2 8v
Cylinder head height (construction figure) (mm)		Validity
126.5 +/- 0.35		1.2 8v
Cylinder head-cylinder block/crankcase non alignment (mm)		Validity
0.1		1.3 JTD
Exhaust valve external diameter (mm)		Validity
27.20 - 27.50		1.2 8v
Flatness of bottom surface (mm)		Validity
0.1		1.3 JTD
Flatness of bottom surface (mm)		Validity
0.1		1.3 JTD
Inlet and exhaust valve stem diameter (mm)		Validity
6.982 - 7.000		1.2 8v
Inlet valve external diameter (mm)		Validity
31.20 - 31.50		1.2 8v
Lower band taper"c" (-)		Validity
20˚		1.2 8v
Nominal lift (mm)		Validity
105.5 ± 0.05		1.3 JTD
Spring height (mm)			Validity
21.5			1.2 8v
Under load (daN) 61.4 - 65.5
Spring height (mm)			Validity
31			1.2 8v
Under load (daN) 21.2 - 23.8
Tappet casing housing diameter (mm)		Validity
35.000 - 35.025		1.2 8v
Upper section taper "" (-)		Validity
75˚		1.2 8v
Valve cylindrical section thickness (mm)		Validity
> 1		1.2 8v
Valve guide inner diameter (mm)		Validity
7.022 - 7.040		1.2 8v
Valve stem - valve guide diameter (mm)		Validity
0.022 - 0.058		1.2 8v

03 General