Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)02 · 10 Engine
02 · Engine

Fitting cylinder head (page 2 of 2)

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Partial replacements (1242 16v)
10 EngineFitting cylinder head · page 2 of 2
Diagram showing a torque wrench tool 1860942000 being used on cylinder head bolts
Diagram showing the cylinder head gasket being positioned on the engine block
Diagram showing a cylinder head extension tool 1860988000 being fitted to the cylinder head
  1. Tightening cylinder head retaining bolts to the engine block

    Stage 1: Tighten the bolts to a torque of 3 daNm in the order shown previously.

    Stage 2: Tighten the bolts through 90° using tool 1860942000.

    Stage 3: Further tighten all bolts by 90°.

  2. Position cylinder head gasket on the cylinder head mating surface.
  3. Position the cylinder head extension on the cylinder head, then remove tappet retaining tools 1860988000.
  4. Use wrench 1860834000 to tighten bolts retaining cylinder head extension to cylinder head to the specified torque. Then position the bolt protective caps.
Diagram showing a wrench 1860834000 tightening bolts on the cylinder head extension

Fit the remaining parts by reversing disassembly procedure. Consult the previous paragraph to fit the timing belt.

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.