Removing-refitting inlet manifold

REMOVING-REFITTING INLET MANIFOLD

1. Remove the resonator together with air intake sleeve by undoing the clips shown and unscrewing the retaining bolts. Disconnect the oil vapour recovery pipe from the lower part of the resonator.
2. Disconnect the accelerator control cable
3. Disconnect the connections shown and the brake servo vacuum line from the butterfly valve case.
4. Disconnect pipes (1) and connections (2) from the upper part of the intake manifold.
5. Remove screws retaining the upper part of the inlet manifold using wrench USAG TX 27 or similar, disconnect oil vapour recovery pipe (1) and remove the manifold from the car together with the butterfly valve case.