Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)02 · 10 Engine
02 · Engine

Removing-refitting power unit (page 3 of 7)

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Removing-refitting (1242 16v)
10 EngineRemoving-refitting power unit · page 3 of 7
Diagram showing the resonator and intake sleeve with arrows indicating removal points
Diagram showing the accelerator control cable connection point on the engine
Diagram showing the guard, lambda probe connector, fuse holder, and brake serve vacuum pipe location

  1. Remove the resonator with its intake sleeve by disconnecting the clip shown from the butterfly valve case and unscrewing the retaining bolts. Also disconnect the oil vapour recovery pipe from the lower part of the resonator.
  2. Disconnect the accelerator control cable.
  3. Disconnect the lambda probe connector.
  4. Remove the guard shown in the figure, then disconnect the connector shown in the figure and release the fuse holder from its metal mount.
  5. Disconnect the brake serve vacuum pipe.
Diagram showing the fuse holder being released from its metal mount with arrows pointing to the retaining bolts
Diagram showing the brake serve vacuum pipe connection point with an arrow indicating the disconnection area

Original page

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.