Fitting the stabilizer bar.

1 3 daNm
2 5,6 daNm

Fitting the stabilizer bar.

Tighten the bolts (1) to a torque of 3 daNm and bolt (2) to a torque of 5.6 daNm.

REMOVING-REFITTING REAR SHOCK ABSORBER

Removing the lower bolt fixing the shock absorber to the track control arm.

To remove the shock absorber it is necessary to compress the suspension with a hydraulic jack in order not to damage the threads of the fixing bolts.

Removing the upper bolt fixing the shock absorber.

When refitting, do not fully tighten the shock abosrber fixing bolts. When tightening, refer to the procedure described below (see page 38).