Installation (page 2 of 2)
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Emission control system (1108 Euro 3)
10 EngineInstallation · page 2 of 2
To permit a correct thermal match, apply the specified grease to the Lambda sensor’s thread.
| Type | Component | Description | Q.ty. | |
|---|---|---|---|---|
| - | Grease | EXHAUST PIPE FROM MANIFOLD | ANTISEIZE MATERIA-BORON NITRITE N.G.K. | - |
Note: During tightening, do not exert pressure on the Lambda sensor so as not to cause irreparable damage.
- Tighten the Lambda probe to torque.
| Mounting | Component | Ø | Value (daNm) |
|---|---|---|---|
| - | - | M18 x 1.5 | 4.5 |
- Connect the Lambda probe electrical connector.
| Description | Connector | |
|---|---|---|
| 1 | Lambda sensor-2 | K39 |
- Connect the battery negative terminal.
| Description | Connector | |
|---|---|---|
| - | Battery | A1 |
- Remove the vehicle from the ramp.
Parts & tools for this job For 1998 Fiat Seicento
- PARTExhaust gasketSearch: Fiat Seicento 1998 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.