10 Engine Refitting · page 1 of 2
(Cont. Op. 1008B20)
Follow Op. 1008A44 REAR RIGID SUPPORT of power unit- R+R.
Refitting
Tighten the flexible block fastening nut to the rear rigid support to the correct torque
Fastening Component Ø Value (daNm)
- Nut REAR FLEXIBLE M10 BLOCK 5.1
Complete with Op. 1008A44 REAR RIGID SUPPORT of power unit - R+R.Connect the negative (-) battery terminal
Name Connector
- Battery A1
Remove the vehicle from the hoist.
1008B30 - FLEXIBLE BLOCKS(S) ON SUPPORT GEARBOX SIDE - REPLACE
Removal
Position the vehicle on a hoist.
Disconnect the negative (-) battery terminal.
Name Connector
- Battery A1
Follow Op. 4450B10 FRONT WHEEL (one) - R.R.Follow Op. 7055B42 SUPPLEMENTARY WHEEL HOUSING (One) - R.R.Place a hydraulic jack under the gearbox.
Unscrew the flexible block screw.
Unscrew the flexible block screws and remove the block.
Refitting
Tighten the screw securing the flexible block to the rigid support to the correct torque
Fastening Component Ø Value (daNm)
- Screw FLEXIBLE BLOCK GEARBOX SIDE M10 6.5
Tighten the screws fastening the flexible block to the car body to the correct torque
Fastening Component Ø Value (daNm)
- Screw FLEXIBLE BLOCK GEARBOX SIDE M8 3.0
Remove the hydraulic jack.
Complete with Op. 7055B42 SUPPLEMENTARY WHEEL HOUSING (one) - R+R.Complete with Op. 4450B10 FRONT WHEEL (one) - R.R.Connect the negative (-) battery terminal
Name Connector
- Battery A1
Remove the vehicle from the hoist.
02 Engine
