Installation
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Power unit mounts (1108 Euro 3) › Installation
10 EngineInstallation · page 1 of 2
Note: Before loosening the bolt securing the rear flexible block, make a reference mark ready for refitting.
Installation
1108 Euro 3
- Connect the rear flexible block to the rigid mount and tighten the nut to torque.
| Mounting | Component | Ø | Value (daNm) |
|---|---|---|---|
| - Nut | REAR FLEX-IBLE MOUNTING | M10 | (Engine side) 5.1 |
- Refit the power unit rear mount to the differential.
- Tighten to torque the nuts on the bolts securing the rear rigid mount to the differential.
| Mounting | Component | Ø | Value (daNm) |
|---|---|---|---|
| - Nut | POWER UNIT RIGID REAR MOUNT | M12 | (Differential side) 9.1 |
- Tighten to torque the bolts securing the rear flexible block to the floor.
| Mounting | Component | Ø | Value (daNm) |
|---|---|---|---|
| - Bolt | REAR FLEX-IBLE MOUNTING | M8 | (Body-shell side) 2.5 |
- Remove the hydraulic jack.
- Connect the negative (-) battery terminal.
| Description | Connector |
|---|---|
| - Battery | A1 |
- Remove the car from the ramp.
Parts & tools for this job For 1998 Fiat Seicento
- PARTEngine gasket setSearch: Fiat Seicento 1998 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.