Reassembly

(Cont.d Op. 2125C20)

4. Withdraw the reversing gear inhibitor control (4a), spring (4b), circlip (4c), spring (4d) and the reversing gear inhibitor (4e).

1. Slacken the nuts (1a) and remove the reversing gear control inhibitor sector (1b).
2. Slacken the nuts (2a) and remove the gearshift lever (2b) with the gearshift lever support jointing unit (2c).

Reassembly

• Assemble the gearshift lever with the jointing unit in the gearshift lever support and tighten the fastening nuts.
• Assemble the reversing gear control inhibitor sector and fasten it with the corresponding screws and nuts.
• Insert the reversing gear inhibitor, lower spring, circlip, upper spring and reversing gear inhibitor control on the gearshift lever.
• Insert the gearshift lever knob completely.
• Assemble the reversing gear inhibitor cable and fasten it with the circlips.

Reassembly

• Insert the ends of the gear engagement and selection hoses in the gearshift control lever support.
• Insert the clamps on the hose sheaths.
• Connect the gear selection hose with the corresponding washers and fasten it with the circlip.
• Fit the gear engagement hose.
• Re-position the gearshift control lever support and fasten it with the corresponding screws.

(Cont.d)