Refitting
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Front suspension › Refitting
‹ Prev 4410b - front suspension wishbones overviewNext › 4410b42 - lower front suspension wishbone (complete with articulated joint) (one - remaining) - r+r. following op. 4410b
44 Suspension and wheelsRefitting
Note: Modify the tool as described.
- Remove the pins and disassemble the tool.
- Widen the holes using a drill Ø 10.5 mm.
- Reassemble the tool replacing the pins with screws Ø 8 mm.
- Slacken the nut and remove the front fastening screw.
- Slacken the screws (2a) of the rear U-bolt (2b).
| Name | Code |
|---|---|
| 2b Puller | 1.847.035.000 |
- Remove the lower front wishbone.
Refitting
- Re-position the lower front wishbone.
- Tighten the rear U-bolt screws to the specified torque
| Fastening | Component | Ø | Value (daNm) |
|---|---|---|---|
| 2 | Screw | LOWER FRONT WISHBONE M12 | 8.8 |
- Tighten the front fastening nut to the specified torque
| Fastening | Component | Ø | Value (daNm) |
|---|---|---|---|
| 3 | Nut | LOWER FRONT WISHBONE M12 | 8.8 |
- Tighten the nut of the lower front wishbone articulated joint to the specified torque
(Cont.d.)
‹ Prev 4410b - front suspension wishbones overviewNext › 4410b42 - lower front suspension wishbone (complete with articulated joint) (one - remaining) - r+r. following op. 4410b
Parts & tools for this job For 1998 Fiat Seicento
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTFront shock absorbersSearch: Fiat Seicento 1998 front shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.