Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)11 · 70 Bodywork
11 · Body & interior

Safety belts a

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Mouldings and protections › Safety belts a
70 BodyworkSafety belts a

SAFETY BELTS A

  1. Apply a cord of polyurethane glue GURIT ESSEX HU3 or similar product (approximately 2 mm in diameter) at regular intervals so that it will not act on the surfaces previously glued to the vehicle.
  • Apply the specific glue with a spatula and apply polyurethane glue again as described above.

NOTE Do not wait longer than 8 minutes between the first and second application of glue.

  1. Remove the double adhesive tape liner.
Diagram showing the application of a 2mm cord of glue onto a molding strip, labeled with callout numbers 1 and 2.
  1. Position the molding on the roof duct.
  • Press the surface with a roller to embed the base of the molding in the polyurethane glue.
  1. Apply adhesive tape between the molding and the rood to hold the molding in position.

NOTE Wait at least 24 hours before using the vehicle to allow molding gluing.

Diagram showing the installed molding along the roof duct of a car, with callout numbers 1 and 2 indicating components.

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.