Sun roof systems

Operation 7030B54 · Sliding roof

The following adjustments are permitted: vertical direction (adjustment to the seal) for the sun roof (assembly); lengthwise and vertical direction for each individual plate.

To adjust the sun roof (assembly) in a vertical direction (adjustment to the seal), carry out the operations described below.

1. Loosen the fixing bolts (1a), (1b), (1c) and nuts (1d).

2. Proceed with adjusting the position of the sun roof (assembly).

When the adjustment is over, tighten the nuts and bolts fixing the sun roof (assembly) to torque.

To adjust the plate in a vertical direction, carry out the operations described below.

It is advisable to loosen one pair of bolts at a time, front or rear, when carrying out the adjustment.

1. Loosen a fixing bolt, one on the right and the corresponding one on the left, and proceed with the adjustment.

When the adjustment is completed, tighten the bolts fixing the sun roof (assembly) plate.

To adjust the plate in a lengthwise direction, carry out the operations described below.

1. Loosen the fixing bolts and proceed with the adjustment.

When the adjustment is completed, tighten the bolts fixing the sun roof (assembly) plate.