Removal and Installation Removal All Vehicles | -
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. NOTE:Make sure the filler cap does not become contaminated. Remove the reservoir filler cap. - Disconnect the electrical connector.
- Remove the cap.
| | -
Using a suitable suction device drain the reservoir. | Vehicles with manual transaxle | -
Disconnect the clutch master cylinder feed hose. | All vehicles | -
Remove the brake fluid reservoir. - Detach the two retaining clips.
| | -
Remove and discard the O - ring seals. | Installation | -
NOTE:Install new O - ring seals. To install, reverse the removal procedure. | |