In-vehicle Repair Special Tool(s) | Oil seal remover 303-293 (21-143) | | Installer, crankshaft oil seal 303-395 (21-171) | | Installer, crankshaft oil seal 303-684 (21-243) | Removal | -
Remove the timing belt. For additional information, refer to timing belt in this section. | | -
NOTE:FRONT marking and position of the timing belt pulley thrust washer. Detach the crankshaft timing belt. - Pull off the crankshaft pulley hub.
- Remove the key and timing belt thrust washer.
| | -
Remove the crankshaft front oil seal. | Installation | -
NOTE:Correct seating of the sealing lip on the installing sleeve. Slide the crankshaft front oil seal onto the special tool until it is approximately in the middle. | | -
Slide the special tool onto the crankshaft until it makes contact. | | -
Slide the crankshaft front oil seal along the special tool by hand onto the crankshaft until it touches the oil seal carrier. | | -
NOTE:Use the bolt of the crankshaft vibration damper. Pull in the crankshaft front oil seal using the special tool, until it is home. | | -
NOTE:FRONT marking and position of the timing belt pulley thrust washer. Fit the crankshaft pulley hub. - Slide on the timing belt thrust washer and key.
- Fit the crankshaft pulley hub.
| | -
Installing the timing belt. For additional information, refer to timing belt in this section. | | |