Removal Special Tool(s) | Engine Lifting Brackets 49 UN30 3050 (303-050) | | Support Hanger 49 L017 4A0 | WARNING:Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. WARNING:Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injures or death and damage. Fuel can also irritate skin and eyes. | -
Remove the air intake pipe. For additional information, refer to: Intake Air System Components (303-12 Intake Air Distribution and Filtering, Removal and Installation). | | -
Remove the battery. For additional information, refer to: Battery (414-01 Battery, Mounting and Cables, Removal and Installation). | | -
Remove the radiator. For additional information, refer to: Radiator (303-03 Engine Cooling, Removal and Installation). | | -
Remove the front pipe. For additional information, refer to: Exhaust Downpipe (309-00 Exhaust System, Removal and Installation). | | -
Remove the transmission. For additional information, refer to: Transmission - Vehicles With: 5-Speed Manual Transmission (R15M) (308-03 Manual Transmission/Transaxle, Removal), Transmission - Vehicles With: 5-Speed Manual Transmission (S15M) (308-03 Manual Transmission/Transaxle, Removal), Transmission - Vehicles With: 5-Speed Manual Transmission (S15MX) (308-03, Removal). | | -
NOTE:Position and secure the P/S oil pump out of the way with a rope. Remove the P/S oil pump with the oil hoses and pipes still connected. For additional information, refer to: Power Steering Pump - 2.5L Duratorq-TDCi (WL) Diesel (211-02 Power Steering, Removal and Installation). | | -
NOTE:Position and secure the A/C compressor out of the way with rope or wire. Remove the A/C compressor with the pipes still connected. For additional information, refer to: Air Conditioning (A/C) Compressor (412-03 Air Conditioning, Removal and Installation). | 8. Remove the components in the order indicated in the following illustration(s) and table(s). Removal Details Item 3 : Engine | -
Install the SST to the cylinder head by using bolt (99784 1020 or M10X1.25, 8T, length 20mm {0.79 in}) as shown. - Tightening torque 43.1—60.8 Nm {4.40—6.10 kgf·m, 31.8—44.8 ft·lbf}.
| | -
Suspend the engine using the SST. | |