| General Procedures General Equipment All vehicles | | -
Place the vehicle on a level surface. | | | -
Ensure that the tire pressures are to specification and that the vehicle is not overloaded. | Vehicles with conventional headlamps | | -
Repeatedly operate the headlamp leveling switch and then set it to "0". | Vehicles with adaptive front lighting | | -
Use WDS to make certain that the front wheels are in the straight ahead position. | All vehicles | | -
Set the measuring screen of the beam setting equipment to the correct headlamp adjustment setting. Refer to: Specifikationen (417-01, Specifications). | | | -
Adjust the dipped beams so that the light/dark boundary touches the horizontal line. | | | -
NOTE:Some scattered light from the low beam may lie above the 15 degree line. Adjust the headlamps so that the rising line of the boundary line lies at the intersection of horizontal line and the 15 degree line (left-hand drive vehicle shown). | |
