ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Front Fog Lamp Adjustment > < Headlamp Adjustment

S-MAX.Galaxy 2006.5 (03.2006-)

Exterior Lighting - Headlamp Masking—Vehicles With: Cornering Lamps S-MAX/Galaxy 2006.5 (03/2006-)
General Procedures

  1. Print out the corresponding templates at the end of this operation.
  1. Measure dimension X on the printout of the template.
  1. Calculate the enlargement/reduction factor Y for the photocopier using the following formula: Y=Z÷X×100.
  1.  
    • X = measurement on the printout of the template in mm
    • Y = enlargement/reduction factor in %
    • Z = original dimension in mm = 100
  1. Enlarge/reduce the printout with a photocopier by the calculated percentage.
  1. Compare dimension X on the photocopy with the original dimension.
  1. Cut out the prepared template for the headlamp.

  1. Align the template on the lens of the headlamp.
  1.  
    1. Template
    1. Alignment edges on the headlamp lens

  1. Align the template on the lens of the headlamp.
  1.  
    1. Template
    1. Alignment edges on the headlamp lens
  1. CAUTION:
    CAUTION:Take extra care not to scratch the headlamp lens.
    Copy the outline of the template with a suitable pen onto the headlamp lens.
  1. Remove the template.
  1. Mask the marked area with opaque black adhesive tape.
  1. Repeat steps 12 to 14 for the headlamp on the other side.

  1. Template for the right-hand headlamp

  1. Template for the left-hand headlamp

Front Fog Lamp Adjustment > < Headlamp Adjustment