Coolant temperature SENSOR - R.R.

Operation 1056B50 · MULTI-POINT INJECTION SYSTEM (MPI)

2.0 TB, 2.4 20V

Removing

- Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

2.4 20V

See in Op. 1048A28 vacuum air circuit resonator pipe - r+r

2.0 TB

See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.

See in Op. 1048A50 air inlet pipe to turbocharger - r + r

2.0 TB, 2.4 20V

1. Disconnect the electrical connection from the engine coolant temperature sensor.

2. Undo the engine coolant temperature sensor and remove it.

Refitting

- Place the engine coolant temperature sensor in its housing and tighten it to the recommended torque.

- Connect the electrical connection to the engine coolant temperature sensor.

2.4 20V

See in Op. 1048A28 vacuum air circuit resonator pipe - r+r

2.0 TB

See in Op. 1048A50 air inlet pipe to turbocharger - r + r

See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.

2.0 TB, 2.4 20V

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

- Connect the negative battery lead.

3.0 V6, 3.2 V6

Removing

See in Op. 5530B10 BATTERY - R.R.

- Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

- [7040D12]

- [7040D14]

See in Op. 1048A28 vacuum air circuit resonator pipe - r+r

1. Disconnect the electrical connection from the engine coolant temperature sensor.

2. Undo the engine coolant temperature sensor and remove it.

Refitting

- Fit the engine coolant temperature sensor and tighten it to the recommended torque.

- Connect the electrical connection to the engine coolant temperature sensor.

See in Op. 1048A28 vacuum air circuit resonator pipe - r+r

- [7040D14]

- [7040D12]

- Connect the negative battery terminal.