300Tdi Discovery
CLUTCH
3
REPAIR
Refit
7. Fit the master cylinder and fixings.
8. Fit push-rod to pedal and retain with clevis pin
and washer.
9. Raise fasica fuse box panel.
10. Fit fluid pipe to master cylinder.
11. Bleed system.
See Bleed Hydraulic System
RELEASE BEARING ASSEMBLY
Service repair no - 33.10.07
Remove
1. Remove gearbox.
See MANUAL GEARBOX,
Repair, R380 Manual Gearbox
2. Remove clutch slave cylinder.
See Slave
Cylinder
3. Withdraw retainer staple.
4. Withdraw bearing and sleeve. If required, press
bearing off sleeve. Fit replacement bearing with
domed face outwards from sleeve.
5. Remove spring clip and fixings.
6. Withdraw release lever assembly.
Refit
7. Smear pivot with grease and fit release lever and
retain with spring clip and bolt.
8. Smear release bearing sleeve inner diameter
with molybdenum disulphide base grease.
9. Reverse removal procedure. 1 to 4.
