300Tdi Discovery
33
CLUTCH
4
REPAIR
SLAVE CYLINDER
Service repair no - 33.35.01
NOTE: All flexible and pipe connections
and joints should be tightened to
15 Nm.
Remove
1. Evacuate clutch system fluid at slave cylinder
bleed valve.
2. Disconnect fluid pipe.
3. Remove two securing bolts and withdraw slave
cylinder and backing plate.
4. If dust cover is not withdrawn with slave cylinder,
withdraw it from bell housing.
Refit
5. Withdraw dust cover and backing plate from
slave cylinder.
6. Coat both sides of backing plate with Hylomar
P232M waterproof jointing compound.
7. Locate backing plate and dust cover in position
on slave cylinder.
8. Fit slave cylinder, engaging push-rod through
centre of dust cover and with bleed screw
uppermost.
9. Reconnect fluid pipe.
10. Replenish and bleed clutch hydraulic system.
11. Check for fluid leaks with pedal depressed and
also with system at rest.