Freelander Service Procedures
CHARGING AND STARTING
REPAIRS 86-1-17
Starter motor - K1.8
$% 86.60.01
Remove
1. Disconnect battery earth lead.
2. Remove air cleaner assembly.
PETROL, REPAIRS, Air cleaner - K1.8.
3. Disconnect Lucar connector from starter motor.
4. Remove nut and disconnect battery lead from
starter solenoid.
5. Remove lower nut and bolt securing starter
motor.
6. Remove bolt securing steady bar to engine LH
mounting.
7. Remove upper nut and bolt securing starter
motor.
8. Remove engine steady bar.
9. Remove starter motor.
Refit
1. Clean starter motor and mating face.
2. Ensure gearbox closing plate is in position.
3. Fit starter motor and fit lower bolt but do not
tighten bolt at this stage.
4. Fit engine steady bar, fit bolt securing steady
bar to engine mounting but do not tighten at this
stage.
5. Fit starter motor upper bolt.
6. Tighten starter motor upper and lower nuts and
bolts to 80 Nm (59 lbf.ft).
7. Tighten bolt securing engine steady bar to LH
engine mounting to 25 Nm (18 lbf.ft).
8. Connect battery cable to starter solenoid, fit nut
and tighten to 8 Nm (6 lbf.ft).
9. Connect Lucar to solenoid.
10. Fit air cleaner assembly.
PETROL, REPAIRS, Air cleaner - K1.8.
11. Connect battery earth lead.