Freelander Service Procedures
CHARGING AND STARTING
86-1-16 REPAIRS
Starter motor - KV6
$% 86.60.01
Remove
1. Remove battery carrier.
2. Release starter motor solenoid terminal cover,
remove nut securing battery lead to solenoid
and disconnect battery lead.
3. Disconnect Lucar connector from starter
solenoid.
4. Remove 3 bolts securing starter motor to
gearbox noting that the LH bolt also secures
the mounting bracket for the CKP sensor
multiplug.
5. Manoeuvre and remove starter motor.
Refit
1. Clean starter motor and mating face on
gearbox.
2. Position starter motor to gearbox, align CKP
sensor multiplug bracket, fit and tighten bolts to
45 Nm (33 lbf.ft).
3. Connect battery lead to solenoid terminal, fit
nut and tighten to 13 Nm (9.5 lbf.ft). Secure
terminal cover.
4. Connect Lucar connector to starter solenoid.
5. Fit battery carrier.