LR3/Disco 3
2 .
CAUTION: Failure to loosen the set screws may result in damage to the cylinder block cradle.
Position the cylinder block cradle set screws.
Using the special tool, adjust the set screws until they are below the cylinder block cradle
boss face.
3 .
NOTE :
The cradle must be installed within 20 minutes of the sealant application.
Apply sealant to the cylinder block cradle.
Apply sealant to the 6 places shown.
4 .
CAUTION: Make sure the gasket is installed correctly.
Install the cylinder block cradle.
Install a new gasket.
Install, then evenly and progressively lightly tighten the outer bolts, nuts and Torx screws.
5 .
Align the cylinder block cradle to the cylinder block rear face.
Install and tighten the 2 rear bolts.
Loosen the 2 rear bolts.
Lightly tighten the 2 rear bolts.
