LR3/Disco 3
7 .
Install the EGR valve.
Clean the component mating faces.
Install a new gasket.
Tighten the bolts to 25 Nm (18 lb.ft).
8 .
Connect the vacuum hose to the EGR valve.
9 .
Connect the EGR vacuum hose to the intake manifold.
Clean the component mating faces.
Connect the vacuum hose to the EGR valve.
10 .
Install the throttle body.
Clean the component mating faces.
Install a new gasket.
Tighten the 4 bolts to 10 Nm (7 lb.ft).
11 .
Install the throttle body coolant hose.
Secure the clip.
Remove the hose clamp.
12 .
Secure the wiring harness to the intake manifold.
Secure the wiring harness clip.
13 .
CAUTION: Care must be taken prior to tightening the intake manifold bolts. Make sure the
electrical harness, vacuum and purge valve lines are not trapped.
NOTE :
To aid installation: Position a Torx drive and extension, to the rear LH bank intake manifold Torx
bolt, prior to installing the intake manifold. Retain with tape.
NOTE :
The ignition coils are removed from the illustration for clarity.
Install the intake manifold.
Clean the component mating faces.
Install the gaskets.
Evenly and progressively tighten the bolts in the sequence shown to 10 Nm (7 lb.ft).