LR3/Disco 3
Fuel Pump Module (19.45.03)
Removal
NOTE :
Published : May 26, 2004
WARNING: Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol
Fumes' signs about the vehicle.
WARNING: Do not carry or operate cellular phones when working on or near any fuel related
components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions
may result in personal injury.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near
any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow
these instructions may result in personal injury.
WARNING: The spilling of fuel is unavoidable during this operation. Ensure that all necessary
precautions are taken to prevent fire and explosion.
The fuel pump module comprises of a rear fuel level sender, filter and a fuel pressure regulator. These components
cannot be serviced separately.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the fuel tank. For additional information, refer to
Fuel Tank (19.55.01)
(Section 310-01)
4 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
NOTE :
Note the fitted position.
Release the fuel pump module access flange.
Loosen the screw.
Remove the clamp.