B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Valve Body: Procedures
On-Vehicle Repair
CONTROL VALVE BODY REMOVAL / INSTALLATION
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
NOTE: If a transmission has been disassembled to replace worn or damaged parts and the valves in the control valve body stick repeatedly from
foreign material, the torque converter must be removed and cleaned.
3. Remove the oil pan and oil strainer.
4. Unclip control valve body wire harness.
1) Lift up on wire harness guide and protector and disengage the retaining pins from the solenoid clamps.
5. Disconnect the (1) SS1, SS2, SS3 and CCS/SS4 electrical connectors.
6. Disconnect the (2) Torque Converter Clutch (TCC) solenoid electrical connector.
7. Disconnect the (3) Electronic Pressure Control (EPC) solenoid electrical connector.
8. Remove the detent bolt (1) and spring (2).