B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
18. Install the reverse servo piston and rod.
19. Check the reverse piston travel.
20. Install the a new gasket and reverse piston cover and tighten in sequence shown.
21. Connect the six solenoid connectors to the solenoids.
1) SS1, SS2, SS3 and CCS/SS4 solenoids.
2) TCC solenoid
3) EPC solenoid
NOTE: The wiring guide snaps into place on the solenoid retainers.
22. Install the wiring loom protector and guide.
1) Align the pins in the holes of the solenoid brackets and gently push down.
CAUTION: Excessive pressure may break the locating pins.
23. Test the solenoid valves.
24. Install new O-rings on the oil strainer.
25. Apply petroleum jelly to the O-rings.
