B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Assembly Note
Assembly Note
Caution: Do not lose parts when cleaning or servicing.
1. Thoroughly clean all parts in solvent and blow dry with moisture free compressed air.
Caution: Do not stone, file, or sand valves. This will remove the anodized finish and may result in further main control or transmission
damage.
2. After cleaning the main control valve body, perform the following:
1) Inspect all valve and plug bores for scoring or burrs.
2) Check all fluid passages for obstructions.
3) Inspect all valves and plugs for burrs.
4) Inspect all mating surfaces for burrs or distortion.
5) Inspect all springs for distortion.
6) Check all valves and plugs for free movement in their respective bores.
^
Valves and plugs, when dry, must fall from their own weight into their respective bores.
7) Roll the manual valve on a flat surface to check for a bent condition.
3. Clean and inspect the EPC solenoid screens.
4. Remove and replace all shift solenoid O-rings.
5. Clean and inspect the TCC solenoid.
