CX-7 L4-2.3L Turbo (2007)
3.
Remove inner white plastic clip on passenger side grip handle by pulling down and up. Slide panel away from handle. Mark and discard upper
door panel.
Upper Door Trim Assembly
1.
Attach new replacement upper panel (kit provided) to lower panel using front and rear edge positioning locator pins into lower panel locator holes.
2.
Install and tighten eight (8) locating screws. Do not over-torque screws.Tightening torque: 0.2-0.5 N-m (2-5 kgf-cm)
NOTE:
Carefully position passenger grip from surface side and re-install white plastic clip.
3.
Reset white felt insulation onto upper panel and fix in position with masking tape (kit provided) (front and rear edge).
NOTE:
Confirm Steps 2 & 3 are performed correctly.
Door Panel Installation
1.
Check condition of eight (8) lower plastic door panel fasteners and replace with new fastener(s) (kit provided) if missing or damaged.
2.
Reconnect mirror and window switch connectors (three (3) on driver side, one (1) on passenger side).
3.
Insert inner door latch handle through hole and properly set in door panel (check connection of door cables and door lock connectors).
4.
Install top edge of door panel and carefully align all eight (8) lower plastic door panel fasteners before pressing panel into position.
NOTE:
Do not hit door panel into position as this could cause marring or discoloration.
5.
Remove masking tape protecting black painted door sash area.
6.
Tighten door latch handle screw and install cover.
7.
Tighten armrest screw and install cover (check cover facing up and proper position).
8.
Tighten two (2) passenger side grip handle screws and install plastic handle cover.
9.
Install front A-pillar inner garnish cover.
10.
Perform "Power Window Initialization Procedure" (below) to restore "anti-pinch" and "auto open/close" window features before returning vehicle
to customer or dealer inventory.
POWER WINDOW INITIALIZATION PROCEDURE
1.
Turn ignition to ON position.
