Cylinder head cover
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- B Engine (B) › Cylinder head cover
EngineCylinder head cover
05U0BX-034
Cylinder head cover
- Apply silicone sealant to the shaded areas as shown in the figure.
- Install the cylinder head cover.
Tightening torque:
4.9—8.8 N·m (50—90 cm·kg, 43—78 in·lb)
05U0BX-286
Spark plug
- Apply antiseize compound or molybdenum-based lubricant to the spark plug threads.
- Install the spark plugs.
Tightening torque:
15—23 N·m (1.5—2.3 m·kg, 11—17 ft·lb)
05U0BX-035
Timing belt guide plate, inner
Caution
- Make sure the timing belt inner guide plate is installed in the proper direction.
- Install the timing belt inner guide plate.
Steps After Installation
- Fill the radiator with the specified amount and type of engine coolant. (Refer to page E–5.)
- Connect the negative battery cable.
- Start the engine and check as follows:
(1) Engine coolant leakage.
(2) Ignition timing. (Refer to page B–8.) - Recheck the engine coolant levels.
05U0BX-036
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.