Valve mechanism
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Cylinder Head (B) › Valve mechanism
- Measure the manifold contact surface distortion in the four directions shown in the figure.
Distortion: 0.15mm (0.006 in) max.
- If distortion exceeds specification, grind the surface or replace the cylinder head.
VALVE MECHANISM
Valve and Valve Guide
- Inspect each valve for the following. Replace or resurface the valve if necessary.
- Damaged or bent stem.
- Rough or damaged face.
- Damaged or unevenly worn stem tip.
- Measure the valve head margin thickness of each valve. Replace the valve if necessary.
Margin thickness
IN : 1.0mm (0.039 in)
EX: 1.0mm (0.039 in)
- Measure the length of each valve at the points shown.
Length
Standard
IN : 105.29mm (4.1452 in)
EX: 105.39mm (4.1492 in)
Minimum
IN : 104.79mm (4.1256 in)
EX: 104.89mm (4.1295 in)
- Measure the stem diameter of each valve.
Diameter
IN : 5.970—5.985mm (0.2350—0.2356 in)
EX: 5.965—5.980mm (0.2348—0.2354 in)
- Measure the inner diameter of each valve guide at the points shown.
Inner diameter
IN : 6.01—6.03mm (0.2366—0.2374 in)
EX: 6.01—6.03mm (0.2366—0.2374 in)
- Calculate the valve stem to guide clearance. Subtract the outer diameter of the valve stem from the inner diameter of the corresponding valve guide.
Clearance
IN : 0.025—0.060mm (0.0010—0.0024 in)
EX: 0.030—0.065mm (0.0012—0.0026 in)
Maximum: 0.20mm (0.008 in)
- If the clearance exceeds specification, replace the valve and/or valve guide.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.