Ignition timing, idle speed
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- B Engine › Ignition timing, idle speed
EngineIgnition timing, idle speed
IGNITION TIMING, IDLE SPEED
Preparation
- Check the engine condition (spark plugs, leaks in hoses, etc.).
- Warm up the engine to normal operating temperature.
- Make sure all accessories are OFF.
Note
- When using an externally powered timing light and/or tachometer, connect it to the power connector (Blue: 1-pin).
Caution
- Do not ground the power connector terminal (Blue: 1-pin); the wiper 20A fuse will be burned.
- Connect a timing light and a tachometer to the diagnosis connector terminal IG–.
Caution
- Be extremely careful when making connections to the diagnosis connector because a mistaken connection will cause a malfunction.
- Connect the SST.
- Set the SST switch A to 1 position and test switch to SELF TEST position.
Note
- If the SST is not used, jump across the (TEN) terminal and the (GND) terminal of the diagnosis connector.
Ignition Timing
Inspection / Adjustment
- Check the idle speed and set it to specification if necessary.
Idle speed: 850 ± 50 rpm (Neutral)
- Verify that the timing mark (Yellow) on the crankshaft pulley is aligned with the timing belt lower cover mark.
Ignition timing: 10° ± 1° BTDC (at idle speed)
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.