Preparation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Preparation › Preparation
EnginePreparation
PREPARATION
SST
05U0BX-005
05U0BX-006
05U0BX-007
05U0BX-008
05U0BX-009
ENGINE OIL
Inspection
- Be sure the vehicle is on level ground.
- Warm up the engine to normal operating temperature and stop it.
- Wait for five minutes.
- Remove the oil level gauge and check the oil level and condition.
- Add or replace oil if necessary.
Note
- The distance between the L and F marks on the level gauge represents 0.8 liter (0.85 US qt, 0.70 Imp qt).
ENGINE COOLANT
Inspection
Coolant level (engine cold)
Warning
- Never remove the radiator cap while the engine is hot.
- Wrap a thick cloth around the cap when removing it.
- Verify that the coolant level is near the radiator filler neck.
- Verify that the coolant level in the coolant reservoir is between the FULL and LOW marks.
- Add coolant if necessary.
Coolant quality
- Verify that there is no buildup of rust or scale around the radiator cap or radiator filler neck.
- Verify that the coolant is free of oil.
- Replace the coolant if necessary.
DRIVE BELT
Inspection
- Remove the air intake pipe.
- Check the drive belts for wear, cracks, and fraying. Replace if necessary.
- Verify that the drive belts are correctly mounted on the pulleys.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.