B Engine (B)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- B Engine (B) › B Engine (B)
EngineB Engine (B)
| Problem | Possible Cause | Remedy | Page |
|---|---|---|---|
| Insufficient power | Insufficient compression | ||
| Malfunction of HLA* | Replace | B–20 | |
| Compression leakage from valve seat | Repair | B–51 | |
| Seized valve stem | Replace | B–49 | |
| Weak or broken valve spring | Replace | B–52 | |
| Failed cylinder head gasket | Replace | B–16 | |
| Cracked or distorted cylinder head | Replace | B–48 | |
| Sticking, damaged, or worn piston ring | Replace | B–56 | |
| Cracked or worn piston | Replace | B–56 | |
| Malfunction of fuel system | Refer to Section F | ||
| Malfunction of ignition system | Refer to Section G | ||
| Others | |||
| Slipping clutch Dragging brakes Wrong size tires |
Refer to Section H Refer to Section P Refer to Section Q |
||
| Abnormal combustion | Malfunction of engine-related components | ||
| Malfunction of HLA* | Replace | B–20 | |
| Sticking or burned valve | Replace | B–49 | |
| Weak or broken valve spring | Replace | B–52 | |
| Carbon accumulation in combustion chamber | Eliminate carbon | — | |
| Malfunction of fuel system | Refer to Section F | ||
| Malfunction of ignition system | Refer to Section G | ||
| Engine noise | Crankshaft- or bearing-related parts | ||
| Excessive main bearing oil clearance | Replace or repair | B–63 | |
| Main bearing seized or heat-damaged | Replace | B–58 | |
| Excessive crankshaft end play | Replace or repair | B–64 | |
| Excessive connecting rod bearing oil clearance | Replace or repair | B–65 | |
| Connecting rod bearing seized or heat-damaged | Replace | B–58 | |
| Piston-related parts | |||
| Worn cylinder | Replace or repair | B–54 | |
| Worn piston or piston pin | Replace | B–57 | |
| Seized piston | Replace | B–56 | |
| Damaged piston ring | Replace | B–56 | |
| Bent connecting rod | Replace | B–57 | |
| Valves or timing-related parts | |||
| Malfunction of HLA* | Replace | B–20 | |
| Broken valve spring | Replace | B–52 | |
| Excessive valve guide clearance | Replace | B–49 | |
| Malfunction of cooling system | Refer to Section E | ||
| Malfunction of fuel system | Refer to Section F | ||
| Others | |||
| Malfunction of water pump bearing | Refer to Section E | B– 6 | |
| Improper drive belt tension | Adjust | ||
| Malfunction of alternator bearing | Refer to Section G | ||
| Exhaust gas leakage | Refer to Section F | ||
| Malfunction of timing belt tensioner | Replace | B–12 |
* Tappet noise may occur if the engine has set idle for an extended period. The noise should dissipate after the engine has reached normal operating temperature. (HLA troubleshooting: Refer to page B–7)
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.