Valve Seat
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Valve Seat › Valve Seat
EngineValve Seat
- Inspect the contact surface of each valve seat and valve face for the following:
- Roughness.
- Damage.
- If necessary, resurface the valve seat with a 45° valve seat cutter and/or resurface the valve face.
- Apply a thin coat of Prussian blue to the valve face.
- Inspect the valve seating by pressing the valve against the seat.
- If blue does not appear 360° around the valve face, replace the valve.
- If blue does not appear 360° around the valve seat, resurface the seat.
- Measure the seat contact width.
Width: 0.8—1.4mm (0.031—0.055 in)
- Verify that the valve seating position is at the center of the valve face.
- If the seating position is too high, correct the valve seat with a 75° cutter and a 45° cutter.
- If the seating position is too low, correct the valve seat with a 35° (IN) or 15° (EX) cutter and a 45° cutter.
- Seat the valve to the valve seat with lapping compound.
- Inspect the sinking of the valve seat.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.