Steps After Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- D Lubrication system › Steps After Installation
Lubrication systemSteps After Installation
Steps After Installation
- Install the under cover.
- Fill with the specified amount and type of engine oil. (Refer to page D–5.)
- Connect the negative battery cable.
- Start the engine and check for leaks.
- Check the oil level and add oil if necessary.
DISASSEMBLY / INSPECTION / ASSEMBLY
- Disassemble in the order shown in the figure, referring to Disassembly Note.
Assemble in the reverse order of disassembly, referring to Assembly Note.
- Oil seal
Disassembly Note .................... page D–12
Assembly Note ...................... page D–13 - Pump cover
Inspect for distortion or damage - Outer rotor
- Inner rotor
- Roll pin
- Spring seat
- Pressure spring
Inspection .......................... page D–12 - Control plunger
Inspect for wear or damage - Pump body
Inspect for distortion or damage
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.