Preparation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Clutch fluid › Preparation
ClutchPreparation
PREPARATION
49 0259 770B
Wrench, flare nut
For loosening and tightening bleeder screw
REPLACEMENT
Note
- The fluid in the reserve tank must be maintained at the 3/4 level or higher during replacement.
Caution
- Be careful not to spill clutch fluid on a painted surface. If this should happen, wash it off immediately.
- Do not mix different brands of clutch fluid.
- Do not reuse the clutch fluid which was drained out.
- Draw the fluid from the reserve tank with a suction pump.
- Remove the bleeder cap from the clutch release cylinder and attach a vinyl hose to the bleeder plug.
- Place the other end of the vinyl hose in a container.
- Slowly pump the clutch pedal several times.
- With the clutch pedal depressed, loosen the bleeder screw with the SST to let fluid escape. Close the bleeder screw with the SST.
- Repeat Steps 4 and 5 until only clean fluid is seen.
- Tighten the bleeder screw.
Tightening torque:
5.9—8.8 Nm (60—90 cm-kg, 52—78 in-lb)
- Add fluid to the MAX mark.
- Check for correct clutch operation.
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.